Securitron SAM2-24 Manual do Utilizador descarregar pdf (Página 2)

PN# 500-10450

Page 2 Rev. B, 02/12

3.1 HARDWARE

10X 20X 8X

Phillips Flat Head

#8 X 3/4” Type “A”

Socket Flat Head

8-32 X 1/2”

Shim Plate

4X 1X 1X

Flush Mount Bracket

Thread Locking Compound

Pack

Floor Install Replacement

Spring Pack (2 Springs)

4 RECOMMENDED TOOLS

Router or Saber Saw Measuring Instrument (Ruler/Tape Measure)

Hammer Masking Tape

Chisel Fish Tape or Lead Wire

Center Punch Wire Strippers/Cutter

Power Drill Crimp Wire Connectors

7/64”, 9,64”, 3/16” & 5/16” Drill Bits Crimp Tool

3/8” Diameter X 82° Countersink Bit Multimeter

Phillips and Standard Screwdrivers

5 INSTALLATION INSTRUCTIONS

5.1 Pre-Installation Survey

It is recommended that an initial on sight survey be performed. A method of mounting should

be determined and an installation plan should be reviewed as follows:

 Physical strength of mounting areas should be strong enough to meet or exceed the holding

force of the required Magnalock.

 Placement of the Magnalock wiring and protection from potential damage due to intruders or

vandals external attack should be considered during the survey.

 Accessibility should be considered for prevention of any potential safety hazard.

The door and frame areas additionally need to be examined for mortising capabilities, sufficient

size and should be free of any internal obstructions. The top-of-door installation is

recommended as the most suitable location for protection from impact attacks.

NOTE:

THE SAM2-24 STRIKE ASSEMBLY IS NOT RECOMMENDED FOR USE IN

ALUMINUM OR STEEL FRAMED DOORS THAT HAVE A CHANNEL RECESS AT THE TOP.

FOR PROPER OPERATION IN HOLLOW METAL DOORS THE STRIKE ASSEMBLY SHOULD

BE MOUNTED IN THE FLUSH MOUNT ARRANGEMENT ONLY!

1 2 3 4 5 6 7 ... 10 11

Sem comentários

Securitron SAM2-24 Manual do Utilizador Página 2